Outer shell SFL (Super Fibre Laminate)

This is the basic Arai outer shell and is therefore sometimes referred to as ‘Standard Fibre’ although it actually is Super fibre. Super fibre provides more strength than other shell materials, yet is still lightweight.
 

Facial Contour System

To offer an even better snug fit and enhancing the comfort to the lower jaw, the Facial Contour System (FCS) works with a foam spring support in the cheek pad that compresses and rebounds, providing the necessary support without excessive pressure
 

Replaceable interior

Completely removable interiors that may be cleaned with mild soap and lukewarm water, rinse well and let it dry for a day, never in a clothes dryer, direct sunlight or near a stove. Different size thicknesses are available to fit those in-between sizes for a custom fit for every rider.
 

Chin bar spoiler

As the “naked” bikes offer a more upright seating position and hardly any wind protection, the chin piece of the Rebel and the pull down chin spoiler are designed to guide the wind around the neck and to improve the aerodynamic, enhancing the wind cheating properties of the helmet.
 

Wide SAI vision

Super AdSis “I” visor offers one of the widest peripheral vision in the business for better performance. Shaping along the upper edge of the shell offer a smooth transition between shield and shell.
 

SuperAdSis LRS (Lever Release System)

Makes visor changes easy. Cleaning or replacing the shield in as matter of seconds.
 

Large operating knobs

Large buttons for convenient operation, even with gloves on
 

Ventilation

One-piece rear exhaust extracts hot, damp air from the helmets interior and improves aerodynamics. Side exhausts create a low pressure behind the rear vent for better hot air extraction, reduced wind noise and prevent buffeting at speed. Brow vents that guide fresh air to the forehead area.
 

Five times inspected

Each Arai helmet goes through five separate quality-control departments: after the shell is made, after painting and graphic completion, after assembly and two in-process inspections
 

Double-D ring device